¢ Dimensions
¢ Installation
1.
With referring the setting manual, perform wire connection.
2.
Install the WLAN adapter in the direction as shown in this figure. If the WLAN adapter is in-
stalled in the wrong direction, water may get into the adapter through the wire, causing failure.
GOOD
3.
Connect the remote controller cable to the connecting cable, and insert it to the connector. Set
the DIP switch (SW1) on the PCB of indoor unit to "2WIRE".
3-11. Wireless LAN adapter (UTY-TFSXZ1)
Top view
38
Top view
Tapping screws
(Accessories)
Reverse direction
- (05-182) -
15
Side view
PROHIBITED
On the floor
On a curved surface
Unit: mm
3. Adaptor/Convertor units