Fujitsu AJ 126LELDH Series Design & Technical Manual page 543

2. Install the rear case.
• When cable is in the wall:
• When cable is in the wall (switch box is used):
• When cable is along the wall:
*: More than 1 mm thick
NOTES:
• When central remote controller (UTY-DCGZ) is installed at the wall directly, install at
a flat wall so that small animals do not enter from the rear side.
• When central remote controller (UTY-DCGZ) is installed at the wall directly, remove
the rubber bush at the rear side.
2-4. Central remote controller (UTY-DCGZ)
Transmission cable
Power supply cable
Rear case
Transmission cable
Switch box
Power supply cable
Front case
Cut off
- (05-43) -
Putty
Trap
Screws
Rear case
Screws
Cable cover*
Epoxy
putty
2. Control units