Lenovo ThinkSystem SR665 V3 User Manual page 111

Figure 58. Installing the front adapter assembly
a. Insert the front adapter assembly into the front chassis.
b. Install the screws to secure the front adapter assembly in place.
Step 6. Connect the cables to the system board assembly and the rear OCP interposer card. See
6 "Internal cable routing" on page
Step 7. Install the system fan cage. See
Step 8. Install system fans. See
Step 9. Install the riser 1 assembly if you have removed it. See
After you finish
Complete the parts replacement. See
Remove the rear OCP interposer card
Follow instructions in this section to remove the rear OCP interposer card.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
281.
"Install the system fan cage" on page
"Install a system fan" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 48
62.
270.
266.
"Install a rear riser assembly" on page
279.
.
Chapter 5 Hardware replacement procedures
Chapter
242.
to ensure that you
101