Install The Intrusion Switch - Lenovo ThinkSystem SR665 V3 User Manual

a. Move the intrusion switch connector in the shown direction to disengage it from the
keyhole.
b. Release the intrusion switch cable from the pre-cut slots on the foam and fan cage bottom.
c. Release the intrusion switch cable from the cable clip.
d. Slide and pull the intrusion switch to remove it from the holder.
After you finish
1. Install a new intrusion switch. See
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube

Install the intrusion switch

Follow instructions in this section to install the intrusion switch.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the intrusion switch onto the fan cage.
"Install the intrusion switch" on page
and "Safety inspection checklist" on page 48
62.
141.
.
Chapter 5 Hardware replacement procedures
to ensure that you
141