Front operator panel (without LCD display)
1
To replace the front I/O module on the rack latch, see
To replace the front I/O module on the media bay:
•
"Remove the front I/O module" on page 121
•
"Install the front I/O module" on page 123
Remove the front I/O module
Follow instructions in this section to remove the front I/O module.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1.
Make preparation for the task.
a.
If the security bezel is installed, remove it. See
b.
If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
c.
Remove the top cover. See
d.
Remove the air baffle. See
Step 2.
Disconnect the cables of the front I/O module from the system board assembly.
Notes:
1
"Rack latches replacement" on page
and
"Safety inspection checklist" on page 48
62.
"Remove the top cover" on page
"Remove the air baffle" on page
Integrated diagnostics panel (with LCD display)
"Remove the security bezel" on page
"Remove the server from rack" on page
277.
70.
.
Chapter 5
Hardware replacement procedures
184.
to ensure that you
245.
63.
121