Remove A Gpu Adapter - Lenovo ThinkSystem SR665 V3 User Manual
Hide thumbs
Also See for ThinkSystem SR665 V3:
- System configuration manual (80 pages) ,
- User manual (256 pages)
Table of Contents
Advertisement
GPU air baffle filler/Add-on air baffle
Figure 85. GPU air baffle filler
Figure 86. Add-on GPU air baffle
Remove a GPU adapter
Follow instructions in this section to remove a GPU adapter.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Depending on the specific type, your GPU adapter might look different from the illustration in this topic.
Procedure
Step 1.
Make preparation for the task.
a.
If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b.
Remove the top cover. See
Step 2.
Remove the riser assembly that has the GPU adapter installed.
GPU adapter on riser 1 or 2 assembly
Note: The following uses riser 1 assembly as an example for illustration. The replacement
procedure is the same for riser 2 assembly.
ThinkSystem SR665 V3 User Guide
126
Scenario
When the GPU air baffle is used, but a riser card is not
installed with a GPU adapter, install this filler on the GPU
air baffle.
If a single-wide FHFL GPU adapter is to be installed on
slot 1, 4, or 7, but the adjacent slot (2, 5, or 8) is left empty
or installed with a half-length adapter, install this add-on
air baffle on the GPU air baffle first.
Note: If the adjacent slot (2, 5, or 8) is installed with a
low-profile Ethernet adapter that use an active optical
cable (AOC), the power of the AOC cable must be limited
to 2.5 W or lower.
and
"Safety inspection checklist" on page 48
62.
"Remove the top cover" on page
"Remove the server from rack" on page
277.
to ensure that you
63.
Advertisement
Table of Contents
