Board - Lenovo ThinkSystem SR665 V3 User Manual

a. Slide the socket lid to OPEN direction.
b. Flip the socket hinge up.
c. Remove the MicroSD card.
After you finish
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Important: Before you return the processor board, make sure that you install the processor socket
covers from the new processor board. To replace a processor socket cover:
1. Slide the cover out from the processor socket of the new processor board.
2. Install the cover on the processor socket of the removed processor board.
• If you plan to recycle the component, see
515.
Demo video
Watch the procedure on YouTube
Install the system I/O board or processor board
Follow instructions in this section to install the system I/O board or processor board.
About this task
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do no
attempt to remove or install it without proper training and qualification.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• After replacing the system I/O board or processor board, always update the server with the latest firmware
or restore the pre-existing firmware.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr665v3/downloads/driver-list/
see the latest firmware and driver updates for your server.
• Go to "Update the firmware" on page 467
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
"Disassemble the system board assembly for recycle" on page
and "Safety inspection checklist" on page 48
62.
for more information on firmware updating tools.
.
Chapter 5 Hardware replacement procedures
to ensure that you
to
259