Lenovo ThinkSystem SR665 V3 User Manual page 157

• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Procedure
Step 1. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack. See
Step 2. Remove the top cover. See
Step 3. Disconnect the M.2 cables from the M.2 backplane.
Figure 106. Disconnecting M.2 cables from M.2 backplane
Step 4. Remove the M.2 backplane.
M.2 backplane on the air baffle
1. Remove the M.2 drive from the M.2 backplane. See
2. Remove the M.2 backplane from the air baffle.
and "Safety inspection checklist" on page 48
62.
"Remove the server from rack" on page
"Remove the top cover" on page 277.
"Remove an M.2 drive" on page
.
Chapter 5 Hardware replacement procedures
to ensure that you
63.
143.
147