Lenovo ThinkSystem SR665 V3 User Manual page 262

Figure 228. Installing the firmware and RoT security module
a. Lower the firmware and RoT security module onto the system I/O board and ensure that the
connector on the module is correctly inserted into the slot on the system I/O board.
b. Tighten the two screws to secure the firmware and RoT security module in place.
After you finish
1. Install any components that you have removed:
• "Rear drive backplane and drive cage replacement" on page 213
• "Install the 7mm drive cage" on page 211
• "Install a rear riser assembly" on page 242
2. Complete the parts replacement. See
3. Update the UEFI, XCC and LXPM firmware to the specific version supported by the server. See
glosse4lenovo.lenovo.com/wiki/glosse4lenovo/view/How%20To/System%20related/
How%20to%20do%20RoT%20Module%20FW%20update%20on%20ThinkSystem%20V3%20machines/
4. Perform OneCLI commands to restore the UEFI settings. See
r_restore_command
5. Perform both OneCLI commands and XCC actions to restore the XCC settings. See
pubs.lenovo.com/lxce-onecli/onecli_r_restore_command
.
restorethexcc.html
6. If there is a software (SW) key, for example, XCC FoD key, installed in the system, inject the key again to
ensure that the key functions properly. See
Note: If you need to replace the processor board together with the firmware and RoT security module,
update the VPD before injecting the key. See
7. Optionally, do the following if needed:
• Hide/observe TPM.
• Update the TPM
• Enable UEFI Secure
Demo video
ThinkSystem SR665 V3 User Guide
252
"Complete the parts replacement" on page
.
firmware.
Boot.
https://pubs.lenovo.com/lxce-onecli/onecli_
and
https://pubs.lenovo.com/xcc2/NN1ia_c_
Using Lenovo Features on
Update the Vital Product Data
279.
https://
Demand.
(VPD).
https://
.