Nom_Delay - Panasonic KX-UDS124 Administrator's Manual

NOM_DELAY

Value Format
Description
Value Range
Default Value
RTP_PORT_MIN
Value Format
Description
Value Range
Default Value
RTP_PORT_MAX
Value Format
Description
Value Range
Default Value
Document Version 2013-03
Integer
Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
1–7 (´ 10 ms)
Note
•
This setting is subject to the following conditions:
–
This value must be greater than or equal to "MIN_DELAY"
–
This value must be less than "MAX_DELAY"
2
Integer
Specifies the lowest port number that the SIP-CS will use for RTP
packets.
1024–45150 (even number only)
Note
•
The value for this setting must be less than or equal to
"RTP_PORT_MAX" - 4000.
•
Changing this setting may affect the number of simultaneous
calls that can be made. Therefore, when setting this parameter,
be aware that the maximum number of necessary ports can be
calculated as shown below:
No. of lines ´ No. of channels ´ 2 ´ 1 (No. of terminals)
16000
Integer
Specifies the highest port number that the SIP-CS will use for RTP
packets.
5024–49150 (even number only)
Note
•
The value for this setting must be greater than or equal to
"RTP_PORT_MIN" + 4000.
•
Changing this setting may affect the number of simultaneous
calls that can be made. Therefore, when setting this parameter,
be aware that the maximum number of necessary ports can be
calculated as shown below:
No. of lines ´ No. of channels ´ 2 ´ 1 (No. of terminals)
29000
4.5.2 RTP Settings
Administrator Guide 213