Panasonic KX-UDS124 Administrator's Manual page 245

3.
Select "Register H/S" and then press
Register H/S
Cancel Base
Select Base
System Lock
Change PIN
4.
Select a base number and then press
Note
•
You can register four separate bases on your S-PS.
Register H/S
Base 1
Base 2
Base 3
Base 4
5.
Hold down
6.
When registration has completed, "Registered" will be displayed.
Note
•
You can register multiple S-PSs continuously. However, PS Registration mode will terminate if no
registrations are detected within 2 minutes. All SIP-CSs controlled by the Super Master CS will enter
PS Registration mode at the same time as the Super Master CS. You can register an S-PS to any of
the SIP-CSs.
•
When registering multiple S-PSs, perform the registration procedure on each S-PS individually.
Performing the registration procedure on multiple S-PSs at the same time may result in an error. In this
case, reperform the registration procedure.
•
After registering S-PSs, the Web port will be closed (® see Opening the Web Port in 2.1.1 Before
Accessing the Web User Interface).
•
After registering S-PSs, S-PS firmware update may start automatically. During the firmware update,
the S-PS may reboot up to 3 times. Therefore, you should not remove the battery/batteries of the S-PS.
Document Version 2013-03
until "Please wait..." is displayed.
5.1 PS Registration from Web User Interface
.
.
Administrator Guide 245