Epson Stylus Pro 3800 Service Manual page 122

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.5.2 MOTOR ASSY., ASF
1. Remove the HOUSING, UPPER.
2. Release the cables of the MOTOR ASSY., ASF from the cable hook.
3. Disconnect the connector of the MOTOR ASSY., ASF, shown in
relay connector.
4. Remove the two screws that secure the MOTOR ASSY., ASF and remove the MOTOR
ASSY., ASF. See Figure 4-42.
Two C.B.P. 3 x 8 screws (6 ± 1 kgf.cm)
Put a screwdriver (with a 60 mm or longer shaft is recommended)
C H E C K
P O I N T through the holes on the FRAME ASSY., SUB, RIGHT to remove
the C.B.P 3x8 screws that secure the MOTOR ASSY., ASF as
shown in Figure 4-42.
Be sure to insert the guide pin of the ASF into the positioning
hole of the MOTOR ASSY., ASF.
MOTOR ASSY., ASF
Secure the grounding terminal and the MOTOR ASSY., ASF
together with the C.B.S. 3 x 8 screw at the rear as shown in
Figure 4-42.
DISASSEMBLY & ASSEMBLY
(p107)
See Figure 4-41.
Figure 4-41
positioning point
Disassembly/Assembly Procedure (Group 1)
Left rear side of the printer
cable hook
from the
relay connector
Figure 4-41. Releasing the cables of the MOTOR ASSY., ASF
Right side of the printer
Put the screwdriver
through this hole.
Figure 4-42. Removing the screws from the MOTOR ASSY., ASF
Revision C
C.B.P. 3x8
The MOTOR ASSY.,
ASF and the grounding
terminal are secured
together.
Grounding Wire
(MOTOR ASSY., ASF)
MOTOR ASSY., ASF
122