Epson Stylus Pro 3800 Service Manual page 194

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.11.4 BOARD ASSY., DETECTOR, PW; B
1. Remove the CARRIAGE, ASSY.
2. From the rear side of the CARRIAGE, ASSY., remove the screw that secures the
HOLDER, DETECTOR, PW. See Figure 4-144.
One C.P.B. 1.7 x 8 screw (1.25 ± 0.25 kgf.cm)
3. Disconnect the HARNESS, PW from CN1 connector on the BOARD ASSY.,
DETECTOR, PW; B, and remove the BOARD ASSY., DETECTOR, PW; B.
See Figure 4-145.
DISASSEMBLY & ASSEMBLY
(p189)
Disassembly/Assembly Procedure (Group 1)
Rear side
CARRIAGE, ASSY.
Figure 4-144. Removing the HOLDER, DETECTOR, PW
BOARD ASSY., DETECTOR, PW; B
Figure 4-145. Removing the BOARD ASSY., DETECTOR, PW; B
Revision C
HOLDER, DETECTOR, PW
C.P.B. 1.7x8
HARNESS, PW
CN1
194