Epson Stylus Pro 3800 Service Manual page 190

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
11. Remove the FFCs secured with the two-sided tape to the FRAME ASSY., SUB, RIGHT.
See Figure 4-137.
12. Remove the acetate tape shown in
13. Remove the five screws that secure the FRAME ASSY., SUB, RIGHT and remove it.
See Figure 4-137, 4-138.
Five C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
To remove/install the two of the five C.B.S. 3x6 screws, insert a
C H E C K
P O I N T screwdriver through the holes on the FRAME, ASSY, SUB,
RIGHT shown in Figure
Make sure to carry out the followings when installing the FRAME
ASSY., SUB, RIGHT to the main unit.
Be sure to align the seven positioning holes of the FRAME
ASSY., SUB, RIGHT with the seven ribs on the main frame.
After fastening the screws shown in
reattach the acetate tape, which is removed in step 11., to cover
the screw head and the rib so as not to damage the FFCs with
them.
Right side of the printer
positioning points
Two-sided Tape
Insert a screwdriver through those holes.
Figure 4-137. Removing the FRAME ASSY., SUB, RIGHT
DISASSEMBLY & ASSEMBLY
Figure 4-138.
4-137.
Figure 4-138, be sure to
C.B.S. 3x6
FRAME ASSY., SUB, RIGHT
Disassembly/Assembly Procedure (Group 1)
acetate tape
Figure 4-138. Removing the screws from the FRAME ASSY., SUB, RIGHT
Revision C
C.B.S. 3x6
positioning points
C.B.S. 3x6
positioning points
190