Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
8.
Disconnect the relay connector of the MOTOR ASSY., ASF, and release the
cables from the two cable hooks.
9.
Remove the four screws that secure the ASF, ASSY.
Two SHAFT, MOUNT, PLATEs: (9 ± 1 kgf.cm)
Two C.B.S. (P4). 3 x 8 screws:
10. Lift up the ASF, ASSY., to disengage the two tabs from the main frame and
remove the ASF, ASSY.
See Figure 4-151.
Whenever the ASF, ASSY., is replaced, the corresponding
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out. See Chapter 5
(p208).
<Adjustment Item>
1.
LD Roller Position Adjustment
2.
Reset When ASF Unit Change
DISASSEMBLY & ASSEMBLY
See Figure 4-41.
See Figure 4-151.
(9 ± 1 kgf.cm)
"ADJUSTMENT"
Disassembly/Assembly Procedure (Group 2)
tab
SHAFT, MOUNT, PLATE
Rear side
ASF, ASSY.
C.B.S. (P4). 3x8
Figure 4-151. Removing the ASF, ASSY.
Revision C
tab
SHAFT, MOUNT, PLATE
main frame
C.B.S. (P4). 3x8
199