Epson Stylus Pro 3800 Service Manual page 181

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
21. Align the fold line of the FFCs with the right edge of the main frame, and secure
the FFCs to the main frame with double-sided tape.
22. Fold the FFCs back on themselves so that the folded portion do not extend off the
positions marked on the front side of the main frame, and adjust the FFCs to take
any slack.
23. Secure the FFCs with acetate tape on the position shown in
When folding back the FFCs with the following steps, make sure
C A U T I O N
that the gap between FFCs are 5 mm or less.
24. Fold back the FFCs on the position shown in
with acetate tape.
25. Route the FFCs on the COVER, HOUSING, LOWER, and secure them to the
COVER, HOUSING, LOWER with double-sided tape.
DISASSEMBLY & ASSEMBLY
Figure 4-120.
See Figure 4-121.
Figure 4-121, and secure the FFCs
Disassembly/Assembly Procedure (Group 1)
Mark
Acetate tape
Acetate tape
Mark
Figure 4-120. Securing the FFC
Within 5 mm
Within 5 mm
Acetate tape
Figure 4-121. Routing the FFCs on the Right Side of the Main Frame
Revision C
Double-sided tape Right edge of main frame
Main frame
Mark
FFC
Double-sided tape
COVER, HOUSING, LOWER
181