Epson Stylus Pro 3800 Service Manual page 141

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
6. Remove the E-ring and the washer from the left side of the SHAFT, PAPER
GUIDE, BOARD PAPER.
7. Pull the SHAFT, PAPER GUIDE, BOARD PAPER to the right to push out the
parallel pin from the SPUR GEAR, 14.4, and pull out the parallel pin from the
SHAFT, PAPER GUIDE, BOARD PAPER.
8. Remove the SPUR GEAR, 14.4 from the SHAFT, PAPER GUIDE, BOARD
PAPER.
9. Remove the E-ring and the washer from the SHAFT, PAPER GUIDE, BOARD
PAPER.
10. Pull the SHAFT, PAPER GUIDE, BOARD PAPER to the right.
Insert the SPUR GEAR, 14.4 into the SHAFT, PAPER GUIDE,
BOARD PAPER as shown in the
parallel pin into the hole.
Insert the SHAFT, PAPER GUIDE, BOARD PAPER into the
connection groove of the CAM, PAPER GUIDE, BOARD
PAPER on the left end of the main unit.
DISASSEMBLY & ASSEMBLY
Figure 4-63, and insert the
Disassembly/Assembly Procedure (Group 1)
CAM, PAPER GUIDE,
BOARD PAPER
Connection Groove
SHAFT, PAPER
GUIDE, BOARD
PAPER
Step 6 Step 6
E-ring washer
Figure 4-63. Removing the SHAFT, PAPER GUIDE, BOARD PAPER
Revision C
Step 9 Step 9
E-ring washer
Step 7
PARALLEL PIN
Step 8
SPUR GEAR, 14.4
GUIDE, PAPER
GUIDE, BOARD
PAPER, LEFT
141