Epson Stylus Pro 3800 Service Manual page 169

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.9.8 CABLE ASSY., ASP
When reassembling the CABLE ASSY., ASP, make sure to follow
C A U T I O N
the procedure described from
may not be maintained.
DISASSEMBLY
1. Remove the HOUSING, UPPER.
2. Remove the COVER, CR. (p152)
3. Remove the INK, SYSTEM, ASSY.
4. Remove the PRINT HEAD. (p161)
5. Carry out step 1. to step 11. of "4.3.3.15 BASE, ENCLOSURE" (p111)
the BASE, ENCLOSURE.
6. Disconnect the cables from CN63, CN69, CN70, CN71 and CN72 on the BOARD
ASSY., MAIN.
7. Remove the two screws that secure the HOLDER,FFC,TUBE.
Two C.B.P. 3 x 8 screws (6 ± 1 kgf.cm)
8. Slide the HOLDER,FFC,TUBE in the direction of the arrow to release the two
hooks, and remove the HOLDER,FFC,TUBE.
DISASSEMBLY & ASSEMBLY
p171
. Otherwise, the product quality
(p107)
(p153)
Disassembly/Assembly Procedure (Group 1)
to pull out
Hooks
Figure 4-101. Removing the HOLDER,FFC,TUBE
CN69
CN70
CN71
CN72
CN63
Figure 4-100. Disconnecting the Cables
HOLDER,FFC,TUBE
Revision C
C.B.P. 3x8
169