Fine Adjustment Of Scan Positions (Function Code 54) - Brother MFC-9130CW Service Manual

1.4.17 Fine adjustment of scan positions (Function code 54)

<Function>
This function allows you to adjust the scan start/end positions on the ADF and document glass.
<Operating procedure>
(1) Press the 5 and 4 keys in this order in the initial state of the maintenance mode.
"SCAN START ADJ." is displayed on the LCD.
(2) The "
that you want to adjust the start position. If you want to adjust the start position of the
ADF, press
(3) Duplex scanning models
The "
them that you want to adjust the start position.
Press the
Single-side scanning models
Go to step (4).
(4) The current correction value for the scanning position will be displayed on the LCD.
(Correction values can be adjusted in 11 steps from +5 to -5 (mm).)
(5) Press the
(6) Press the SET key. "ACCEPTED" is displayed on the LCD, and the machine returns to
the initial state of the maintenance mode.
: ADF : FB" will appear on the LCD after two seconds. Select one of them
key, and if you want to adjust that of the document glass, press
: FRONT : BACK" will appear on the LCD after two seconds. Select one of
key for the first side, and press the
key to increase the correction value and the
key for the second side.
5-35
key.
key to lower it.
Confidential