Error Message List - Brother MFC-9130CW Service Manual

If the Adjustment of inter-color position alignment (auto) fails while being in process, "ERROR
66-1" is displayed on the LCD. If you press the
the error are shown as follows. Refer to the following list for the troubleshooting.

■ Error message list

Error message
FAILED REGIST
TONER EMPTY #
NG * L:C080 R:M105
NG R-L:C030
NG PWM L120 R180
NG PWM R-L:080
NG CNT R100 L100
NG S-POSI R:080
NG SKEW:120
NG PWM R-P L:080
NG XMARGIN:M191
Cover is Open
* # indicates the toner color (Y, M, or C) of which cartridge became empty.
■ Printing of misregistration correction chart
Press the Mono Start key to clear the error. Perform the
Adjustment of inter-color position alignment (auto) again. If the
error recurs, clean the belt unit and the drum units of all four
colors and then perform the adjustment again. If the error still
recurs, replace the belt unit and the drum units of all four colors.
*
Replace the empty toner cartridge and press the Mono Start
key to clear the error. Perform the Adjustment of inter-color
position alignment (auto) again.
Press the Mono Start key to clear the error. Perform the
Adjustment of inter-color position alignment (auto) again.
Close the joint cover ASSY.
Fig. 5-15
5-41
key with the error displayed, the details of
Measure
Confidential