Brother MFC-9130CW Service Manual page 72

Code 1 Code 2
A0 12 Receive buffer full during operation except receiving
into memory.
A0 13 Decoding error continued on 500 lines or more.
A0 14 Decoding error continued for 15 seconds or more.
A0 15 Time-out: 13 seconds or more for one-line
transmission.
A0 16 RTC not found or carrier OFF detected for 6 seconds.
A0 17 RTC found but no command detected for 60 seconds
or more.
A0 19 No video data to be sent.
A0 20 Color fax continuous reception impossible
(Low toner level)
A8 01 RTN, PIN, or ERR received (Sender)
A9 01 RTN, PIN, or ERR received (Recipient)
AA 18 Receive buffer full during receiving into memory.
B0 01 Polarity inversion detection
B0 02 Unable to receive the next-page data.
B0 03 Unable to receive polling even during turn-around
transmission due to call reservation.
B0 04 PC interface error.
C0 01 No common modulation mode or failed to poll.
C0 02 Unable to detect JM.
C0 03 Unable to detect CM.
C0 04 Unable to detect CJ.
C0 10 Cannot finish V. 34 negotiation or training.
C0 11 Modem error detected during V. 34 negotiation or
training.
C0 20 Modem error detected during sending of commands.
C0 21 Modem error detected during receiving of commands.
C0 22 Control channel connection time-out.
C0 30 Modem error detected during sending of video signals.
C0 31 Modem error detected during receiving of video
signals.
E0 01 1300 Hz signal detection failure during opposite
communication inspection operation.
E0 02 PB signal detection failure during opposite
communication inspection operation.
E0 03 Command not detected from RS232C in opposite
communication.
Cause
2-33
Refer to:
4.14.7
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.14.7
4.13.2
4.13.2
4.13.2
4.13.2
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
Confidential