Installing The Panel Firmware; Checking Firmware Version; Installing The Firmware Using Usb Flash Memory; (Usb Direct Interface Model Only) - Brother MFC-9130CW Service Manual

7.1

Installing the Panel Firmware

The following two methods are available for installing the firmware.
- Installing using USB flash memory (USB direct interface model only)
- Installing using computer
7.1.1

Checking firmware version

Check whether the panel firmware installed is the latest version. (Refer to
firmware version" in this
If it is the latest version, there is no need to install the firmware.
If it is not, make sure to install the firmware in accordance with "7.1.2 Installing the firmware
using USB flash memory" or
7.1.2

Installing the firmware using USB flash memory

(USB direct interface model only)

To install the machine firmware, save the program file to the USB flash memory, directly
connect it to the machine, and select the program file.
Note:
- You cannot install the firmware using USB flash memory in the Deep Sleep mode. Gently
touch the LCD to quit the Deep Sleep mode before installing the firmware.
- Make sure that the USB flash memory drive has enough space to save the program file.
- If installing the firmware using a USB flash memory fails and an error message is
displayed on the LCD or letters on the LCD disappear, install the firmware using a
computer referring to
<Procedures>
(1) Save the program file (such as LZXXXX_$.djf) which is necessary for installing the
firmware to the USB flash memory.
(2) While the machine is in the ready state, connect the USB flash memory drive to the USB
port on the front of the machine.
(3) When the machine recognizes the USB flash memory, "Select a Function" is displayed on
the LCD. Press the Direct Print key on the LCD. The files in the USB flash memory are
displayed on the LCD.
(4) Select and press the file name you want to install. When "Press OK to start printing" is
displayed on the LCD, press the OK key on the LCD. "Program updating/Do not turn off"
is displayed on the LCD and installation is started. During installation, do not turn off the
power of the machine.
(5) When the install is finished, the machine automatically restarts.
(6) When firmware installation has been completed, remove the USB flash memory from the
USB port.
chapter.)
"7.1.3 Installing the firmware using computer"
"7.1.3 Installing the firmware using
4-13
"1.1.1 Checking
in this chapter.
computer".
Confidential