Adjustment Of Color Registration; Adjustment Of Inter-Color Position Alignment) (Function Code - Brother MFC-9130CW Service Manual

1.4.21 Adjustment of color registration

(Adjustment of inter-color position alignment) (Function code 66)

<Function>
This function allows service personnel to forcibly activate the adjustment of color registration
(adjustment of inter-color position alignment) function which is usually executed automatically
under a specified condition. If adjustment of inter-color position alignment (auto) fails because
toner reaches its life, etc, you can adjust inter-color position alignment manually.
The end users are allowed to perform "Adjustment of inter-color position alignment
without registration sensor calibration (auto)", "Printing of misregistration correction chart" and
"Adjustment of inter-color position alignment (manual)" only.
Note:
If an error occurs after executing Maintenance mode 66, upgrade the firmware to the latest
one. (Refer to
execute Maintenance mode 66 again.
This function has the following functions.
Function
Adjustment of inter-color
position alignment
without registration
sensor calibration (auto)
Printing of
misregistration
correction chart
Input of sensor offset
value
Adjustment of inter-color
position alignment
(manual)
Adjustment of inter-color
position alignment
including registration
sensor calibration (auto)
■ Adjustment of inter-color position alignment without registration sensor
calibration (auto)
<Operating procedure>
(1) Press the 6 key twice in the initial state of the maintenance mode.
"REGISTRATION" is displayed on the LCD.
(2) Press the SET key. "PLS WAIT 66-1" is displayed on the LCD, and adjustment of
inter-color position alignment is automatically done.
(3) When this operation is completed without an error, "COMPLETED" is displayed on the
LCD.
(4) Press the Cancel key to return the machine to the initial state of the maintenance mode.
Memo:
If the Adjustment of inter-color position alignment without registration sensor calibration
(auto) fails while being in process, "ERROR 66-1" is displayed on the LCD.
Refer to the error message list on
"1.1 Installing the Firmware " in Chapter
Automatically correct misregistration
between colors that occurs as the number
of printed pages increases and time
passes.
Print the chart that you check for an input
value when manually correcting
misregistration between colors.
Unavailable for maintenance work.
Using the chart, manually correct
misregistration between colors that occurs
as the number of printed pages increases
and time passes. This is performed when
automatic adjustment fails.
After the sensitivity adjustment of
registration sensor, correct misregistration
between colors that occurs as the number
of printed pages increases and time passes.
P5-41
4.) After upgrading the firmware,
Description
for the troubleshooting.
5-39
LCD
REGISTRATION
PRINT CHART
OFFSET
ADJUST
SET
REGISTRATION
ADD
REGISTRATION
Confidential