Panasonic TC0938450-015CE Operating Instructions Manual page 28

7 Configure the basic settings of the unit [Basic]
[UPnP (Auto port forwarding)]
Select "On" or "Off" to determine whether or not to use the port forwarding function of the router.
To use the auto port forwarding function, the router in use must support UPnP and the UPnP must be enabled.

Default: Off
Note

Due to auto port forwarding, the port number may sometimes be changed. When the number is
changed, it is necessary to change the port numbers registered in the PC and recorders, etc.

The UPnP function is available when the unit is connected to the IPv4 network. IPv6 is not supported.

To check if auto port forwarding is properly configured, click the [Status] tab on the "Maintenance" page, and
check that the "Enable" is displayed for "Status" of "UPnP". (section 15.3) When "Enable" is not
displayed, refer to "Cannot access the unit via the Internet." in20 Troubleshooting.

When the "UPnP (Auto port forwarding)" setting is changed, the "Auto port forwarding" setting under"UPnP"
on the [Network] tab of the "Network" page also changes to the same setting.
[DDNS]
Select "Viewnetcam.com" or "Off" to determine whether or not to use "Viewnetcam.com".
By selecting "Viewnetcam.com" and clicking the [Set] button, the registration window for "Viewnetcam.com"
will be displayed in a newly opened window.
Follow the on-screen instructions to register with "Viewnetcam.com".
Refer to section 13.4.3 or the "Viewnetcam.com" website (http://www.viewnetcam.com/) for further information.

Default: Off
Note

When the "DDNS" setting is changed, the "DDNS" setting on the [DDNS] tab of the "Network" page
also changes to the same setting.
[Recommended network setting for internet]
The recommended settings for connecting to the Internet are performed here.
By clicking the [Set] button, a dialog displaying how the following settings will change is displayed.
Click the [OK] button after checking the settings to change the settings to the displayed values.

[JPEG/H.264] tab on the "Image" page
–
[H.264(1)]/[H.264(2)]
–
[Internet mode (over HTTP)]: On
–
[Transmission priority]: Best effort
–
[Max bit rate (per client)*]: Max. 1024 kbps, Min. 128 kbps
–
[H.264(1)]
–
[Image capture size]: VGA
–
[H.264(2)]
–
[Image capture size]: QVGA

[Network] tab on the "Network" page
–
[Common]
–
[Max RTP packet size]: Limited(1280byte)
28 Operating Instructions