Table of Contents
Advertisement
[Detection sensitivity]
Adjust the sensitivity of motion detection in the VMD area using the slider. The settings can be configured for
each area individually. The larger the value is set, the higher the sensitivity level becomes.
The current value (1 (low) - 15 (high)) will be displayed below the slider.
Default: 8
[Delete] button
Click the [Delete] button corresponding to the area to be deleted. The outline of the selected area will be
deleted.
[Area No. notification]
When "Panasonic alarm protocol notification >>" is clicked, the [Notification] tab of the "Alarm" page will be
displayed. (section 10.5)
VMD information addition
[Information addition]
Select "On" or "Off" to determine whether or not to add VMD information to superimposed image data.
The VMD information can be searched by some of Panasonic network disk recorders. Refer to the operating
instructions of the connected devices for further information about the functions and settings.
Default: Off
Note
When the camera is performing pan, tilt, zoom, or focus operations, adjusting the brightness, or operating
in auto mode, VMD information is added.
10.3.1 Set the VMD areas [VMD area]
Set the areas to activate the VMD function.
IMPORTANT
When the settings are being configured on the setup menu, sometimes the VMD function may not work
correctly.
1.
Set the video motion detection area by dragging the mouse on the screen.
The designated area will become the VMD area "1(White)" and the outline will be displayed.
When 2–4 VMD areas are set, each area will be numbered in order. The areas will be identified
by the respective outline colors. The "Status" of the outline to be set for the area will become
"On".
10 Configure the alarm settings [Alarm]
Operating Instructions
43
Advertisement
Table of Contents
