Table of Contents
Advertisement
11 Configure the settings relating to the authentication [User mng.]
11 Configure the settings relating to the
authentication [User mng.]
The settings relating to the authentication such as users and PCs restrictions for accessing the unit with a PC or
cellular phone/mobile terminal can be configured on the "User mng." page.
The "User mng." page has 3 tabs; the [User auth.] tab, the [Host auth.] tab and the [System] tab.
11.1 Configure the settings relating to the user
authentication [User auth.]
Click the [User auth.] tab on the "User mng." page. (section 6)
The settings relating to the authentication of users who can access this unit from the PC or a cellular phone/
mobile terminal can be configured on this page. Up to 18 users can be registered.
Note
When user authentication has failed to pass (authentication error) 8 times within 30 seconds using the same
IP address (PC), access to the unit will be denied for a while.
[User auth.]
Select "On" or "Off" to determine whether or not to authenticate the users.
Default: Off
[Authentication]
Set the user authentication method.
Digest or Basic: Uses Digest or Basic authentication.
Digest: Uses Digest authentication.
Basic: Uses Basic authentication.
Default: Digest or Basic
Note
When the [Authentication] setting has been changed, close the web browser, and then access the unit
again.
For other devices such as network disk recorders, unless otherwise stated, Digest authentication is not
supported. (As of December, 2012)
[User name]
Enter a user name.
Available number of characters: 1 - 32 characters
Unavailable characters: " & : ; \
48
Operating Instructions
Advertisement
Table of Contents
