Configure The Settings Relating To Rs485 [Rs485] - Panasonic TC0938450-015CE Operating Instructions Manual

8 Configure the settings related to images [Image]
The controls shown inside the red box are not used by the Thermal Camera.
[Zoom] Buttons

: Click this button to adjust the zoom ratio to the "Wide" side.

: Click this button to set the zoom ratio to x1.0.

: Click this button to adjust the zoom ratio to the "Tele" side.
Control pad buttons

Left-click on the control pad or buttons to adjust the horizontal/vertical position of the camera
(panning/tilting).

Panning/tilting speed will be faster if a clicked point gets farther from the center point of the control pad. It
is also possible to pan/tilt the camera by dragging the mouse.

Zoom can be adjusted by right-clicking. When an upper/lower area of the control pad is right-clicked, the
displayed image will be zoomed in/out on.

Zoom can also be adjusted using the mouse wheel.

Note that the Thermal Camera does not support optical zoom or physical pan/tilt – the Pan/Tilt/Zoom
controls are digital only, within an existing image.
8.5 Configure the settings relating to RS485
[RS485]
IMPORTANT - The settings within the RS485 tab of the setup menu are preconfigured in the Thermal
Camera, and must not be modified.
The correct RS485 settings are as follows:

RS485 Transmission: On

Communication: 2-line

Baud Rate: 19200bps

Data bit: 8bit

Parity Check: None

Protocol: Custom

Unit address: 01
36 Operating Instructions