Configure The Vmd Settings [Vmd Area] - Panasonic TC0938450-015CE Operating Instructions Manual

[Image capture size]
Select the capture size of images to be transmitted to the FTP server or of an image to be attached to the alarm
E-mail.
Picture (Camera) mode VGA [4:3]
Picture (Camera) mode VGA [16:9]

Default: VGA
[Image compression rate upon alarm detection]
Select "On" or "Off" to determine whether or not to change the image quality of "Quality1" (section 8.2) upon
alarm detection.

On: Images will be transmitted with the image quality selected for "Image quality upon alarm detection".

Off: Does not change the image quality upon alarm detection.

Default: Off
[Image quality upon alarm detection]
Image quality can be changed upon an alarm occurrence. Select the image quality from the following.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low

Default: 5 Normal

10.3 Configure the VMD settings [VMD area]

Click the [VMD area] tab on the "Alarm" page. (section 6) The VMD areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
IMPORTANT

The alarm occurrence indication button (section 1.2) will be displayed when motion is detected by the

VMD function.

The alarm occurrence indication button will be displayed when receiving a command alarm or video loss
alarm.

Depending on the network environment, notification may be delayed even when "Real time" is selected for
"Alarm status update mode" on the [Basic] tab of the "Basic" page (section 7.1).

The VMD function is not the dedicated function to prevent thefts, fires, etc. We are not responsible for any
accidents or damages occurring in case.
10 Configure the alarm settings [Alarm]
QVGA/VGA
Not supported by the Thermal Camera
Operating Instructions 41