Table of Contents
Advertisement
[Community]
Enter the community name to be monitored.
Available number of characters: 0 - 32 characters
Default: None (blank)
IMPORTANT
When using the SNMP function, it is necessary to enter the community name. When no community name
is entered, the SNMP function will not work.
[System name]
Enter a system name to be used to manage the unit with the SNMP function.
Available number of characters: 0 - 32 characters
Default: None (blank)
[Location]
Enter the name of the location where the unit is installed.
Available number of characters: 0 - 32 characters
Default: None (blank)
[Contact]
Enter the E-mail address or the phone number of the SNMP manager.
Available number of characters: 0 - 255 characters
Default: None (blank)
13.6 Configure the settings relating to the FTP
periodic image transmission [FTP img. trans.]
Click the [FTP img. trans.] tab on the "Network" page. (section 6)
The settings relating to the periodic transmission of images to an FTP server can be configured on this page. To
transmit images to an FTP server periodically, it is necessary to configure the settings of the FTP server in
advance (section 12.2). Refer to section 13.7 for descriptions of how to configure schedules of image
transmission.
IMPORTANT
Depending on the network line speed or the network traffic, images may not be transmitted at the exact
designated interval or period.
When "On" is selected for both of the alarm image transmission function and the FTP periodic image
transmission function, the alarm image transmission function will be given priority over the FTP periodic
image transmission function. For this reason, images may not be transmitted at the exact designated
interval or period if alarms occur frequently.
13 Configuring the network settings [Network]
Operating Instructions
85
Advertisement
Table of Contents
