17 Using the IP Setting Software
Changing Network Settings
When changing settings related to the network settings, such as connection mode, IP address, and subnet mask,
click the [Network Settings] button in [IP Setting Software] screen.
The "Network Settings" screen is displayed. Enter each item and then click the [Save] button.
Note
By unchecking the "Wait for camera restarting." checkbox, multiple cameras can be continuously
configured.
For further information about each setting of the "Network Settings" page, refer to section 13 .
IMPORTANT
It may take for around 2 minutes to complete to upload the settings to the unit after clicking the [Save]
button. The settings may be invalidated when the LAN cable is disconnected before completing the upload.
In this case, perform the settings again.
When using a firewall (including software), allow access to all UDP ports.
98
Operating Instructions