Configure The Settings Relating To Image And Positions [Image/Position] - Panasonic TC0938450-015CE Operating Instructions Manual


Enter a multicast IP address after checking available multicast address.
[Multicast port] *2
Enter the multicast port number (used to transmit images from the unit).
 Available port number: 1024 - 50000 (Only even numbers are available.)
 Default: 37004
Note

The following port numbers are unavailable since they are already in use.10669, 10670
[Multicast TTL/HOPLimit]
Enter a value for "Multicast TTL/HOPLimit".

Available value: 1-254

Default: 16
IMPORTANT

When transmitting an H.264 image via a network, the transmitted image sometimes may not be
displayed depending on the settings of a proxy server or a firewall. In this case, refer to the network
administrator.

When two or more network interface cards are installed on the PC in use, the network interface card(s)

not used for receiving images should be invalidated when displaying images using the multicast port.
[Smoother live video display on the browser (buffering)]
Perform settings to display unit images on the viewer software.

On: Images are temporarily stored on the computer and are displayed smoother.

Off: Images are displayed in real-time and are not stored on the computer.

Default: Off
IMPORTANT

If it appears that there is a delay in the images being displayed, select "Off".
It is necessary to designate the unicast port number when "Unicast port (MANUAL)" is selected for "Transmission type".
*1
It is necessary to designate the multicast IP address when "Multicast" is selected for "Transmission type".
*2
8.4 Configure the settings relating to image and
positions [Image/Position]
Click the [Image/Position] tab on the "Image" page. (section 6)
*2
8 Configure the settings related to images [Image]
Operating Instructions 35