Panasonic KX-TVP150 User Manual page 33

2.2.3 Connecting a Data Terminal or a
Printer to the VPS
,
Communication
parameter
Data Termial Ready (DTR) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (output)
This signal line is turned ON by the unit to indicate that it
is ON LINE. Circuit DTR ON does not indicate that com-
munication has been established with the printer. It is
switched OFF when the unit is OFF LINE.
Data Carrier Detect (DCD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (input)
The ON condition is an indication to data terminate
(DTE) that the carrier signal is being received.
1
If the Panasonic printer which is used has a (KX-PI 1D or
KX-P17) board and is connected to the KX-TVP150, set
the communication parameters below.
-::
..',
. . . .
-
'.
2
If the Panasonic data terminal is a KX-D4985 or
KX-D4920 and is connected to the KX-TVP150, the
default value of the communication parameter is the same
as that of the KX-TVP150.
If the KX-D4910D is connected to the KX-TVP150, set
the baud rate of the KX-D491OD to 9600 Baud, the other
default value is the same as that of the KX-TVP150.
M-2-20
Configuration & Installation
Manager 's Guide