Table of Contents
Advertisement
3.3.1 Hardware Settings
Light-Off
Sequence for
Message Waiting Lamp
This is the dialing sequence that the VPS must perform to
cause the PBX to turn off the waiting lamp on an exten-
sion.
The light-off Sequence for the message waiting lamp has
the same letters and dial codes as the transfer sequence. It
is set to 'W702X#' (Wait for 1 second- Dial 702, Extension
and #).
Call Waiting Sequence
This sequence is used by the VPS to perform call waiting
when the extension being called is busy. The default value
is "1."
Release Sequence for Call
Waiting
This sequence is used by the VPS to release call waiting.
The default value is "F" (Flash).
. . .
3.3.1.4.2
Inband Signaling Parameters
These parameters are used if the PBX sends DTMF tones
to the voice processing system to indicate the state of the
call (busy, answered, disconnect, etc.). The Inband Integra-
tion Parameter (described in section 3.3.1.4.1) must be
enabled for the VPS to use these codes. If PBX Type is set
to a KX-T series system, the Inband Signaling Parameters
will automatically default to the proper codes.
The table in the following page describes the DTMF codes,
call state and typical conditions where a PBX would send
the code.
M-3-l l-l
(1292-G)
System Administrator
Manager's Guide
Advertisement
Chapters
Table of Contents
