Table of Contents
Advertisement
3.3.5
Utility Command
Note:
Set Password (PASS)
On line Service Control
(ONLN,
OFLN)
Bulletin Board Message
List (BREP)
Print Reports At
Specified Time (PSET)
Device Error Display
(ELOG)
Print All of the VPS
Parameters (GPRN)
Note:
Utility
Command List
(HELP)
The data terminal used must be equipped with communi-
cations software that supports the Xmodem file transfer
protocol.
The System Administrator
can use this command
to
change the system password in order to ensure system
security. Valid passwords can be up to eight alphanumeric
characters long.
There are two passwords : 1 -
Administrator
2 -
System Reset/Clear
These commands can be used to turn all on line services on
and off. For example, it is necessary to disable on line ser-
vices while deleting a mailbox,
because this operation
involves the updating of a large number of system tables.
The recording status of the tree-structured bulletin board
messages is displayed along with the number of any exten-
sions to which calls are transferred when particular mes-
sages are selected.
If a printer or a data terminal is connected to the VPS via
the RS-232C port, the System Administrator
can output
the following
system usage reports: Disk Usage Report,
Port Usage Report and Call Account Data Report. Once
the time is specified by using PSET utility command, the
reports will be output at the specified time every day.
The system administrator can diagnose the VPS by getting
the error log of devices such as CO card, DSP card, CPU
card, and Hard disk.
Prints out all of the VPS parameter settings (output to
screen).
This command
is only valid in the "ASCII
terminal"
mode.
The HELP command displays the list of available utility
commands.
M-3-26
System Administrator
Manager's Guide
Advertisement
Chapters
Table of Contents
