Table of Contents
Advertisement
3.3.1
Hardware Settings
Period of Time Before
No-Answer
Pause Time
Outgoing Call Setup
Sequence
Operator Transfer
Sequence
:,
This is for the periodic port usage reports. The VPS can
discriminate between a local and long distance call and
reports the outgoing call and the calling time for billing. It
is set to 1 at the factory but can be set from 0 to 8.
This is the amount of time that the VPS will wait before
concluding that there will be no answer to the call. The
factory setting is 30 seconds but it can be set from 10 to 60
seconds in 10 second increments.
The pause duration. The default value is 2 seconds, and the
range of allowable values is 1 - 9 seconds.
.' . . .
This is the sequence of codes used by the VPS to make a
call to an outside line. The default value is "WW," which
means that the system waits 2 seconds and then dials the
outside phone number.
Example:
9W = [93 + l-second wait + dial outside phone number
The process of ending a transaction and transferring the
caller to the operator, attendant, or other PBX extension is
programmed by using several of the eight letters and twelve
dial codes.
D : Disconnecting
F : Hook Flash
R : Ring Back Tone Detection
S : Silence Detection
T : Dial Tone Detection
W : Wait for I second
X : Extension dialing
A : Answer
1,2,3, . ,9,0,*,# : Dial Codes
L
The sequence is carried out by the VPS before dialing the
operator's extension. You can set up to 12 digits. The fac-
tory setting is FWWX (Flash - Wait for 2 seconds - Dial -
Extension).
M-3-10
(1292-G)
System Administrator
Manager 's Guide
Advertisement
Chapters
Table of Contents
