Alarm Codes (Basic Control Panel) - ABB ACS550-01 User Manual

ACS550 User's Manual
Alarm
Code
2022
2023
2024
2025
Note 1. Even when the relay output is configured to indicate alarm conditions (e.g. parameter
1401

Alarm Codes (Basic Control Panel)

The Basic Control Panel indicates Control Panel alarms with a code, A5xxx. The
following table lists the alarm codes and descriptions.
Code
5001
5002
5010
5011
5012
5013
5014
5015
5018
5019
5020
5021
5022
5023
5024
5025
5026
5027
5028
5029
5030
5031
Display
2 This alarm warns that the Start Enable 2 signal is missing.
START ENABLE
MISSING
• To control Start Enable 2 function, use parameter 1609.
To correct, check:
• Digital input configuration.
• Communication settings.
Emergency stop activated.
EMERGENCY
STOP
If this alarm code appears, refer to the appropriate accessory manual.
Signals that a the drive is performing a First Start evaluation of motor
FIRST START
characteristics. This is normal the first time the motor is run after motor
parameters are entered or changed. See parameter 9910 (
RUN
1 = 5 (
RELAY OUTPUT ALARM
Drive is not responding.
The communication profile is incompatible with the drive.
The panel's parameter backup file is corrupted.
Drive is controlled from another source.
Rotation direction is locked.
Button is disabled, because start is inhibited.
Button is disabled, because drive is faulted.
Button is disabled, because local mode lock is on.
Parameter default value can't be found.
Writing a non-zero value is prohibited (can only write a zero value).
Group or parameter does not exist or parameter value is inconsistent.
Group or parameter is hidden.
Group or parameter is write protected.
Modification is not allowed while the drive is running.
Drive is busy, try again.
Write is not allowed while upload or download is in progress.
Value is at or below low limit.
Value is at or above high limit.
Value is invalid – doesn't match any values in the discrete values list.
Memory is not ready, try again.
Request is invalid.
Drive is not ready, e.g due to Low DC voltage.
Description
) for a description of motor models.
) or 16 ( / )), this alarm is not indicated by a relay output.
FLT ALARM
Description
209
MOTOR ID
Diagnostics