ABB ACS550-01 User Manual page 67

ACS550 User's Manual
Group 01: Operating Data
This group contains drive operating data, including actual signals. The drive sets the
values for actual signals, based on measurements or calculations. You cannot set
these values.
Code Description
0102 SPEED
The calculated speed of the motor (rpm).
0103 OUTPUT FREQ
The frequency (Hz) applied to the motor. (Also shown by default in OUTPUT display.)
0104 CURRENT
The motor current, as measured by the ACS550. (Also shown by default in OUTPUT display.)
0105 TORQUE
Output torque. Calculated value of torque on motor shaft in % of motor nominal torque.
0106 POWER
The measured motor power in kW.
0107 DC BUS VOLTAGE
The DC bus voltage in VDC, as measured by the ACS550.
0109 OUTPUT VOLTAGE
The voltage applied to the motor.
0110 DRIVE TEMP
The temperature of the drive power transistors in Centigrade.
0111 EXTERNAL REF 1
External reference,
0112 EXTERNAL REF 2
External reference,
0113 CTRL LOCATION
Active control location. Alternatives are:
0 =
LOCAL
1 = 1
EXT
2 = 2
EXT
0114 RUN TIME (R)
The drive's accumulated running time in hours (h).
• Can be reset by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0115 KWH COUNTER (R)
The drive's accumulated power consumption in kilowatt hours.
• Can be reset by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0116 APPL BLK OUTPUT
Application block output signal. Value is from either:
• PFC control, if PFC Control is active, or
• Parameter 0112
EXTERNAL REF
0118 DI1-3 STATUS
Status of the three digital inputs.
• Status is displayed as a binary number.
• 1 indicates that the input is activated.
• 0 indicates that the input is deactivated.
0119 DI4-6 STATUS
Status of the three digital inputs.
• See parameter 0118
0120 AI1
Relative value of analog input 1 in %.
1, in rpm or Hz – units determined by parameter 9904.
REF
2, in %.
REF
2.
1-3 .
DI STATUS
67
1
2 3
DI DI DI
Start-Up