Tuning – Parameters; Fault And Alarm Adjustments - ABB ACS550-01 User Manual

26
2. Edit parameter 9902 to select the appropriate macro.
• Assistant Control Panel – Use either of the following:
– Use the Start-up Assistant, which displays the macro selection immediately
– Refer to "Parameters Mode" on page 31, for parameter editing instructions.
• Basic Control Panel: Refer to "Parameters Mode" on page 39, for parameter
editing instructions.
Tuning – Parameters
The system can benefit from one or more of the ACS550 special features, and/or
fine tuning.
1. Review the parameter descriptions in "Complete Parameter Descriptions" starting on
page 65. Enable options and fine tune parameter values as appropriate for the
system.
2. Edit parameters as appropriate.

Fault and Alarm Adjustments

The ACS550 can detect a wide variety of potential system problems. For example,
initial system operation may generate faults or alarms that indicate set-up problems.
1. Faults and alarms are reported on the control panel with a number. Note the number
reported.
2. Review the description provided for the reported fault/alarm:
• Use the fault and alarm listings on pages 201 and 207 respectively (or page 209
for the Basic Control Panel's alarm listing), or
• Press the help key (Assistant Control Panel only) while fault or alarm is displayed.
3. Adjust the system or parameters as appropriate.
Installation
after motor parameter setup.
ACS550 User's Manual