ABB ACS550-01 User Manual page 38

38
Status Information
When the Basic Control Panel is in the Output mode, the display:
• Top-left shows the control location:
– LOC – indicates that the drive control is local, that
– REM – indicates that the drive control is remote,
• The center of the display provides one Group 01 parameter value at a time, and
makes up to three parameter values available (press UP or DOWN to scroll
through available parameters).
– By default, the display can scroll through three parameters. The particular
– To change the defaults, use parameters 3401, 3408, and 3415 to select the
– You can also scale each item in the scroll list, for example, to convert motor
• Top-right shows the units for the parameter value.
• Bottom-left shows OUTPUT.
• Bottom-right shows the motor direction of rotation. Text display (FWD or REV) is:
– Steady when the motor is up to speed
– Flashing slowly when the motor is stopped.
– Flashing quickly when the motor is accelerating.
Operating the Drive
LOC/REM – The very first time the drive is powered up, it is in the remote control
(REM) mode, and is controlled from the Control Terminal Block X1.
To switch to local control (LOC) and control the drive using the control panel, press
LOC
REM
• Press and release (the display flashes "LOC"), then: the drive stops. Use the
Reference Mode to set the local control reference.
• Press and hold for about 2 seconds (release when the display changes from
"LoC" to "LoC r"), then the drive continues as before. The drive copies the current
remote values for run/stop status and the reference, and uses them as the initial
local control commands.
To switch back to remote control (REM) press
Start/Stop – To start and stop the drive press the START and STOP buttons.
Start-Up
is, from the control panel.
such as the basic I/O (X1) or fieldbus.
default display parameters depend on the value of parameter 9904
. For example, if 9904 = 1, the default display scrolls through
CTRL MODE
parameters 0102 (
SPEED
parameters (from Group 01) in the scroll list. Enter value 0100 to disable any
of the three items in the scroll list. For example, if 3401 = 0100 and 3415 =
0100, then scrolling is disabled and only the parameter specified by 3408
appears in the Control Panel display.
speed to a display of conveyor speed. Parameters 3402...3405 scale the
parameter specified by 3401, parameters 3409...3412 scale the parameter
specified by 3408, etc.
. If you:
), 0104 ( ) and 0105 (
CURRENT
LOC .
REM
ACS550 User's Manual
REM
1.1
OUTPUT FWD
MOTOR
).
TORQUE
A