Totalizer Configuration - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.9.5 Totalizer configuration

Note.

The totalizer tabs are displayed only if the Totalizer option is enabled.

Current totalizer values are displayed in the Indicator view – see Section 4.5.2, page 31
(Operation) and Section 7.8.3, page 84 (Configuration), respectively.

For analog sources, the total value of a signal is calculated by counting pulses produced at a rate
proportional to the input. For digital sources, off / on transitions are counted to produce a batch
total.
Totalizer A (B)
Setup
Mode
Direction
Wrap enable
102
Select the totalizer operation mode:
Off
Standard (9 digits)
Standard (7 digits)
F
0
Timer (digital totalizers only).
Note. Displayed only if
(7 digits) or Timer (digital totalizers only).
When is set to Up, the totalizer counts up from the
Direction
value to the
Predetermined count
If is set to On, the total is reset automatically to the
Wrap enable
value once the
count Predetermined count
If is set to Off, the count stops when the
Wrap enable
value is reached.
Note. A wrap pulse, with a duration of 2 seconds, occurs if the total
reaches the
Predetermined count
is set to Off, the wrap pulse becomes active when the
enable
value is reached and remains active until the totalizer
Predetermined count
is reset. The pulse can be assigned to a relay, digital output or digital
counter.
is set to Standard (9 digits), Standard
Mode
value – see page 104.
value is reached.
value and
Wrap enable
7 Configuration
Preset count
Preset
Predetermined count
is set to On. If
Wrap
OI/RVG200-EN