Process Group Configuration; Setting The Recording Parameters - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.8 Process group configuration

Only the number of groups selected for configuration are displayed in this sub-menu.
For example, if Number of groups (see page 68) is set to 4, only Process Groups 1 to 4 are displayed.
Fig. 7.9 Selecting process group configuration

7.8.1 Setting the recording parameters

Recording
Tag
Recording enable source
80
Enter a tag (maximum 20 characters) to identify the Process Group in the
title bar when any Operator view from that group is displayed.
Refer to Appendix F, page 180 for further information regarding character
use in tags.
Note. Each process group tag
Select a signal source to enable / disable recording of all channels in the
current Process Group. Refer to Appendix A, page 146 for a description
of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to active)
enables recording. A falling edge (active to inactive) disables recording.
Enabled
Disabled
be unique.
must
7 Configuration
OI/RVG200-EN