Email - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder

7.10.5 Email

The recorder can be configured to send emails to a maximum of 6 recipients in response to certain events.
The addressees can all subscribe to the same SMTP server or the recorder can be configured to send
emails via 2 different SMTP servers to a maximum of 3 addressees per server.
Up to 10 independently configurable triggers can be enabled to generate an email when the selected
source becomes active.
When a trigger source becomes active, an internal 1 minute delay timer is started. At the end of that
minute, an email is generated that includes, not only the event that initiated the delay timer, but every other
event that occurred during the delay period together with any enabled reports. The data returned in the
email therefore reflects the real-time alarm state at the time the email was generated, not the state when the
first trigger source became active.
Each email includes a link to the recorder's embedded web server enabling the recorder's data and status
to be viewed remotely using an internet browser on a PC.
Email
Auto Address
Sender Address
OI/RVG200-EN
Touch to toggle between Enabled and Disabled.
Set to Disabled if the sender address must contain a domain literal
address (for example, the recorder's IP address) and enter the address in
the Sender Address field (below).
Select Enabled if the sender address must be a domain name.
Note. Displayed only if Auto Address is set to Disabled.
Enter the address of the email sender.
Note. The address must contain a valid domain name.
.
7 Configuration
119