Appendix A - Signal Sources - ABB ScreenMaster RVG200 Operating Instructions Manual

ScreenMaster RVG200
Paperless recorder
Appendix A – Signal sources
Source Name
Analog Sources
Analog I/P A1 to D24
Comms AIN 1 to 24
Stats 1A max
to
Stats 24B max
Stats 1A min
to
Stats 24B min
Stats 1A avg
to
Stats 24B avg
Math blocks 1 to 24
Error States
AIN A1 to D6 Fail State
Comms AIN 1 to 24 Fail State
Stats 1A
to
Stats 24B fail
Arc media not present
Archive 100% full
Archive 80% full
Table A.1 Signal sources
146
Analog input values (from Analog input module).
Available only if an analog input module is fitted in the relevant position.
Communications analog input values.
Received via the MODBUS serial communications link – see Table B.16, page 164.
Maximum statistics input value.
Value since the totalizer on a given channel last wrap or reset.
Available only if the totalizer option is enabled, only on analog channels and only if the
relevant totalizer is enabled during configuration.
Minimum statistics input value.
Value since the totalizer on a given channel last wrap or reset.
Available only if the totalizer option is enabled, only on analog channels and only if the
relevant totalizer is enabled during configuration.
Average statistics input value.
Value since the totalizer on a given channel last wrap or reset.
Available only if the totalizer option is enabled, only on analog channels and only if the
relevant totalizer is enabled during configuration.
Math block result.
Available only if the Math and Logic option is enabled and the relevant math block is
enabled during configuration.
Analog input failure.
Active when the signal detected at the analog input is outside the Fault Detect Level
specified during configuration – see page 93.
Totalizer input value failure.
Activated when the totalizer fails, cleared when the totalizer wraps or is reset.
Available only if the totalizer option is enabled, only on analog channels and only if the
relevant totalizer is enabled during configuration.
Active when the removable archive media is not present.
Active when the removable archive media is 100% full
Active when the removable archive media is 80% full.
Appendix A – Signal sources
Description
OI/RVG200-EN