2Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

2.4.2 Communication detail settings
Make the settings according to the usage environment.
Item
Transmission Speed
Data Bit
Stop Bit
Parity
Retry
Timeout Time
Host Address
Delay Time
POINT POINT POINT
(1) Communication interface setting by the Utility
(2) Precedence in communication settings
Set this item when change the transmission speed used for
communication with the connected equipment.
(Default: 38400bps)
Set this item when change the data length used for communication
with the connected equipment.
(Default: 8bits)
Specify the stop bit length for communications.
(Default: 1bits)
Specify whether or not to perform a parity check, and how it is
performed during communication.
(Default: None)
Set the number of retries to be performed when a communication
error occurs.
(Default: 3timse)
Set the time period for a communication to time out.
(Default: 3sec)
Make the settings according to the station number (station code) of
the controller to be monitored. (Default: 0)
Set this item to adjust the transmission timing of the communication
request from the GOT. (Default: 0ms)
The communication interface setting can be changed on the Utility's [Communication
Settings] after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Description
2.4 GOT Side Settings
Range
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
7bit, 8bit
1bit, 2bit
None
Even
Odd
0 to 5times
1 to 30sec
<Connecting to X-SEL, SSEL>
0 to 255
<Connecting to PCON, ACON,
SCON> 0 to 15
0 to 300 (ms)
2 - 27
2