Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

14.4.2

Communication detail settings

Make the settings according to the usage environment.
Item
Transmission Speed
Data Bit
Stop Bit
Parity
Retry
*1
Timeout Time
Host Address
Delay Time
14 - 12
14.4 GOT Side Settings
Set this item when change the transmission speed used for communication with the
connected equipment.
(Default: 9600bps)
Set this item when change the data length used for communication with the connected
equipment.
(Default: 8bits)
Specify the stop bit length for communications.
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed during
communication.
(Default: None)
Set the number of retries to be performed when a communication error occurs.
(Default:3times)
Set the time period for a communication to time out.
(Default: 3sec)
Specify the station No. of the servo amplifier to connect the GOT.
(Default: 0)
Set this item to adjust the transmission timing of the communication request from the GOT.
(Default: 0ms)
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication
Settings] after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Description Range
9600bps, 19200bps,
38400bps,
57600bps,
115200bps
7bit/8bit
1bit/2bit
None
Even
Odd
0 to 5times
1 to 30sec
0 to 31
0 to 300ms