Connecting To Fp7 - Mitsubishi Electric GOT2000 Series Connection Manual

■4. Connecting to the communication cassette
(1) Communication settings
Set the commnumication settings for the COM 1 port and COM2 port to connect GOT.
Communication mode
*1
Transmission speed
Modem connection
Data bit
Parity check
Stop bit
Unit No.
*2
Port selection
*1 Indicates only the transmission speeds that can be set on the GOT side.
Set the same transmission speed of the GOT.
For the transmission speed setting on the GOT side, refer to the following.
➠
*2 Set the COM2 port only.
(2) Switch setting on the Communication cassette (AFPX-COM3)
Set the switch on the back.
Switch No.
1
2
3
4
15.5.2

Connecting to FP7

Set the communication using the ladder software "FPWIN GR7".
Assign COM numbers to the CPU module's built-in SCU and communication cassette, and then set the communication
settings.
Communication mode
Station No.
*1
Transmission speed
*1
Data bit
*1
Parity bit
*1
Stop bit
RS/CS
Send wait time (Set value × 0.01ms)
Terminator code STX
Termination setting
Modem initialization
*1 Adjust the settings with GOT settings.
For the setting on the GOT side, refer to the following.
➠
Item
15.4.1 Setting communication interface (Communication settings)
Item
15.4.1 Setting communication interface (Communication settings)
4800bps, 9600bps, 19200bps, 38400bps, 57600bps, 115200bps
Communication cassette
O
1
N
2
3
4
Setting
OFF
OFF
OFF
OFF
4800bps, 9600bps, 19200bps, 38400bps, 57600bps, 115200bps
15.5 PLC Side Setting
Set value
Computer link
No
7bit, 8bit
Odd
1bit
1
Setting details
RS422
Terminating resistor OFF
Set value
MEWTOCOL7-COM
1
7bit, 8bit
Odd
1bit
Invalid
0
Invalid
CR
Do not initialize
15
15 - 41