Ats97, Antenna Diagnostic; Mrst, Perform Hard Reset; Ats97 Parameters - Motorola AT Commands G24-L Developer's Manual

ATS97, Antenna Diagnostic

This command indicates whether an antenna is physically connected to the G24-L RF connector.
This information is also provided by a dedicated hardware signal, which is outputted on pin 41
(ANT_DET) of the interface connector.
Command Type
Execute
Read
The following table shows the ATS97 parameters.
<Parameter>
<info>
Example
// Connect the antenna
ATS97?
001
ATS97
OK
ATS97=?
ERROR
// Disconnect the antenna
ATS97?
000

+MRST, Perform Hard Reset

The +MRST command enables customer software to perform a hard reset to the G24-L unit.
Command Type
Set
April 15, 2008
Syntax Response/Action
ATS97 OK
or:
+CME ERROR: <err>
ATS97? <info>
OK
or:
+CME ERROR: <err>
Table 3-94: ATS97 Parameters
000 The antenna is not connected
001 The antenna is connected
Syntax Response/Action
+MRST OK
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
The Read command indicates whether
the antenna is connected.
Description
Remarks
The Set command performs a graceful
hard reset to the G24-L module.
Note: The Read and Test commands
are not permitted for the
+MRST command.
3-143