Tcp/Ip; Mipcall, Create A Wireless Link - Motorola AT Commands G24-L Developer's Manual

GPRS
+MTKP: 1,0,"! YOUR RECHARGE OF TSH: 250.00 TO 0756706666 IS SUCCESSFUL"
AT+MTKA
+MTKP: 1,0,"Transaction successful!"
AT+MTKA
+MTKM: "VodaFASTA"
+MTKM: 96,5,Recharge,0
+MTKM: 97,5,Transfer,0
+MTKM: 98,5,Report,0
+MTKM: 99,5,Administration,0
+MTKM: 100,5,Exit,0
...

TCP/IP

+MIPCALL, Create a Wireless Link

This command sets up a PPP (Point to Point Protocol) connection with the GGSN (Gate GPRS
Support Node), and returns a valid dynamic IP for the G24-L.
Note:
Command Type
Set
Read
Test
Note:
Note:
3-276
// No other message should be display until this command sent.
// No other message should be display until this command sent.
The DCD line changes only to reflect the state change from command mode to data mode.
Syntax
+MIPCALL= <Operation> [<APN>,
[<User name>, <Password>]]
+MIPCALL?
+MIPCALL=?
The +MIPCALL command does not return the prompt to the terminal until the IP is
received from the provider, or time out has occurred, therefore, no other commands can
be issued in the meantime.
The +MIPCALL command does not have a general ABORT mechanism, therefore a
command cannot be issued until the previous command ends.
When a call exists the dynamic IP address will be returned.
For example:
AT+MIPCALL?
+MIPCALL: 1,"172.17.237.80"
G24-L AT Commands Reference Manual
Response/Action
OK
+MIPCALL: <"local IP address">
or:
ERROR: <err>
+MIPCALL: 0
+MIPCALL: <status>[,<IP>]
+MIPCALL: (list of supported
<operation>s)
April 15, 2008