+MMAD:1,160
there is not enough time for calculation:
AT+MMAD =1,3,100, , ,7,1,5
+CME ERROR: operation not allowed
AT+MMAD =1,0
OK
AT+MMAD?
+MMAD:1,0,10,0,230,0,0,0
+MMAD:2,1,15,0,230,0,0,0
+MMAD:3,2,1,25,100,0,0,0
+MMAD:5,0,1,300,450,0,0,0
OK
AT+MMAD?
+MMAD: 1,0,1,0,230,0,0,0
+MMAD: 2,0,1,0,230,0,0,0
+MMAD: 3,0,1,0,230,0,0,0
+MMAD: 5,0,1,300,450,0,0,0
OK
AT+MMAD=?
+MMAD: (1-3,5),(0-3),(1-255),(0-450),(0-450),(2-255),(1-255),(0-255)
OK
+MPCMC, Continuous PCM Clock
This command defines whether the PCM clock is generated continuously or not, when module is
in digital audio mode (configured by AT+MADIGITAL command).
Note:
April 15, 2008
//Operation not allowed because the parameters are valid but the
// Activate Average calcluation during 1 minute, rate=100,
// samples = 7, report interval = 5 sec.
//converter num=1, report=3, rate=100, low,high, 7,
// duration=1 min, interval = 5.
// Stop Average calcluation and report.
// converter num=1, report=0
// Read monitoring setup values of all A2D's
// Read default values of all A2D's
//Test command - range of all setup parameters and
User is advised not to enable sleep mode feature if he wants to use continuous PCM clock
feature. Otherwise PCM clock will not work correctly while module is in deep sleep
mode.
G24-L AT Commands Reference Manual
Chapter 3: AT Commands Reference
3-153