Modem Configuration And Profile; Modem Register Commands; V, G24-L Response Format; Effects Of Parameter Settings - Motorola AT Commands G24-L Developer's Manual

Modem Configuration and Profile

Modem Configuration and Profile

Modem Register Commands

The G24-L holds certain data items in selected memory space, named Software Registers
(S-registers) and Modem Registers. Some of these registers are used as bitmaps, where one
register holds more than one data item.
All S-registers can be accessed using the S command, described in
page 3-194. Some registers can also be accessed using dedicated commands, detailed below.

V, G24-L Response Format

This command determines the response format of the data adapter and the contents of the header
and trailer transmitted with the result codes and information responses. This command also
determines whether the result codes are transmitted in a numeric or an alphabetic ("verbose")
form. The text portion of information responses is not affected by this setting.
The following table shows the effect that setting this parameter has on the format of information
text and result codes.
<ATV0><cr><lf>
<numeric
code><cr><if>
Command Type
Set
Read
Test
3-190
Table 3-126: Effects of Parameter Settings
V0
<ATV1><cr><lf>
<verbose code><cr><lf>
Syntax
ATV<value>
ATV?
G24-L AT Commands Reference Manual
V1
0 - "OK"
1 - "CONNECT"
2 - "RING"
3 - "NO CARRIER"
4 - "ERROR"
5 - "NO DIALTONE"
6 - "BUSY"
7 - "NO ANSWER"
Response/Action
OK The Set command sets the format of
information responses and result
or:
codes.
+CME ERROR: <err>
<current value> The Read command reads the current
setting of response format.
The Test command for V is not
defined, and therefore is not supported
by the G24-L. The G24-L returns an
error.
"S, Bit Map Registers" on
Information Responses
Remarks
April 15, 2008